Absolutely. It comes with a lanyard, two powerful flat bandsets, and a pair of Ocularis Plugs to attach them to the frame. Everything you need to shoot is included. You supply the ammo.
The Axiom Ocularis™
Owner's Manual
The Axiom Ocularis is a slingshot based on the famous Axiom frame combined with the Ocularis™ band attachment system.
This owner's manual will go over setup of your slingshot and knowledge to make sure you safely and correctly use your new Axiom Ocularis™ slingshot.
Get to know your Axiom Ocularis™ Slingshot
This owners manual will go over setup of your Axiom Ocularis™ Slingshot, and show you how to safely and properly set up and use your slingshot.
Keep scrolling for the video owners manual that covers setup demonstration!
The Shooter Side
This is the side of the Axiom Slingshot that will face you as you shoot.
The Target Side
This is the side of the Axiom that will face the target as you shoot.
OTT (Over The Top)
Band orientation where you shoot the ammo over the top of the forks. (Ocularis™ holds the band to the TOP of the frame.)
TTF (Through The Forks)
Band orientation where you shoot the ammo through the forks. (Ocularis™ holds the band to the SIDE of the frame.)
The Lanyard
A simple piece of paracord that attaches to the handle of your Axiom frame and secures the slingshot to your frame-holding hand.
AXIOM OCULARIS™ SLINGSHOT SETUP INSTRUCTIONS
Step one: Install the Lanyard
Setting up the frame - Installing the lanyard
It is critical to always have the lanyard securely wrapped around the wrist when shooting.
STEP 1. Thread one end of the lanyard through the hole in the end of the Scout frame
STEP 2. Tie a simple overhand knot with BOTH tag ends of the lanyard.
STEP 3. Pull tightly to secure the knot (adjust the position of the knot to vary size of the lanyard.
STEP 4. Check the lanyard to make sure it is secure.
ALWAYS wear the lanyard securely when shooting! The lanyard should firmly but not tight. It should be secure enough to prevent the frame from ever slipping from your hand.
Get to know Ocularis™ Plugs for your Axiom
Flatband Installation
Plugs install on SHOOTER SIDE. Bands wrap AROUND the frame.
Tubular Bands Installation
Plugs install on TARGET SIDE. Bands pull THROUGH the frame.
Seat the bearing
The bearing should be seated half way through the plug.
Do not shoot stones or rocks from any slingshot.
Rocks - no matter how round they look – shoot erratically and shooting them may damage your slingshot and bands.
Due to the uncontrollable nature of shooting non-spherical projectiles, shooting a rock from a SimpleShot slingshot voids any / all warranties.
Step two: Install your Flat Bands or Tubes
Installing Flat Bands On Your Axiom
Step 1.
Place bandset into the Ocularis™ frame. Leave 1/2 inch of band overhang.
Step 2 Option A
Install bearing securely into plug, then press the plug into the frame.
Step 2 Option B
Place the plug into the frame without the bearing installed, then install bearing..
Step 3
Pull bandset while pressing plug into place to fully seat the plug.
Installing Tubes On Your Axiom
Step 1.
Place looped tube through the frame from the SHOOTER side. The loop should be on the TARGET side.
Step 2.
Install bearing securely into plug, then position the loop around the plug with the tubes in the grooves.
Step 3.
Firmly press the plug into the Ocularis frame, pulling the tubes from the shooter side to seat the plug.
Important Axiom Instructions!
Never pull tubes AROUND the frame.
Never pull flatbands THROUGH the frame.
Plugs should not be on the target side with flatbands.
Check your bands before every use.
Which Grip should I use with my Axiom Slingshot?
The Pinch Grip
The Fork-Supported Grip
The Hammer Grip
And now, watch the video to see the Axiom in action!
Ocularis™ Plugs Owners Manual
Installing your Ocularis plugs is quick and simple. Every Ocularis equipped slingshot includes a detailed owners manual. Alternatively, you can watch the video above!